Turning The Power On/Off; Restoring The Factory Settings - Boss KATANA-50 MkII Owner's Manual

Panel Descriptions

Turning the Power On/Off

* Once everything is properly connected (p. 4–p. 7), be sure to follow the
procedure below to turn on their power. If you turn on equipment in
the wrong order, you risk causing malfunction or equipment failure.
* Before turning the unit on/off, always be sure to turn the volume down.
Even with the volume turned down, you might hear some sound when
switching the unit on/off. However, this is normal and does not indicate
a malfunction.
1.
Make sure that the KATANA MkII's [MASTER] knob and the
volume of the devices connected to the KATANA MkII are
set to 0.
* Before connecting your instrument to the KATANA MkII's INPUT
jack, set the [MASTER] knob to the minimum setting (far left).
2.
Turn on the KATANA MkII.
3.
Turn on the power of the devices connected to the LINE
OUT jack and PHONES/REC OUT jack.
4.
Adjust the volume levels for the devices.
Before switching off the power, lower the volume on each of the devices
in your system and then TURN OFF the devices in the reverse order to
which they were switched on.
* If you need to turn off the power completely, first turn off the unit, then
unplug the power cord from the power outlet.
Refer to "To completely turn off power to the unit, pull out the plug
from the outlet" (p. 2).
10

Restoring the Factory Settings

Here's how the settings stored in the KATANA MkII can be returned to
their factory-set condition (factory reset).
1.
While holding down the [PANEL] button, turn the power
on.
Each of the EFFECTS buttons continues blinking consecutively from
the left. When the blinking stops, all of the KATANA MkII's settings
return to the factory-set state.
* It takes approximately 30 seconds for the factory reset to be
completed. Don't turn off the power while the factory reset is in
progress.