Table of Contents
Advertisement
B-CAN Basic Display (cont.)
Hour Meter
The Hour Meter records and displays the total number of hours the
compressor has been engaged. The hour meter will flash when the
system is running, signifying increasing hours.
Compressor Status
The Compressor Status display gives vital information about the
current state of the compressor system. There are four standard
states that will be displayed:
•
NOT READY - The compressor is not ready to engage
for one or more reasons.
•
READY TO ENGAGE - Safety interlocks are met and the
compressor is ready for engagement.
•
ENGAGING - The compressor is starting and waiting for
system air pressure to increase.
•
RUNNING - The compressor is running.
Button Labels
The button labels show the current function of each of the five
buttons. The possible functions for each of the buttons are listed
below:
Button #1 - This button will always attempt to toggle the state of the
compressor.
Button #2 - This button label will be blank.
Button #3 - This button will flash an orange triangle with an exclamation point inside
whenever there are active warnings. Pressing the button will toggle the display of the
warnings. If no warnings are active, this button will be blank and have no function.
Button #4 - This button will either display MENU or will be blank. If the button shows
MENU, pressing it will access the menu if the system is off.
Button #4 & #5 - The function of these buttons will depend on how the
system is configured. Possible functions are controlling the generator,
hydraulics, and/or toggling between high and low pressure if the system
is setup for dual pressure.
29
B-CAN
309743
Advertisement
Table of Contents
