Compressor General Overview - Boss 8060 UBI Operator's Manual

Operation

Compressor General Overview

Operation of the 8060 UBI PTO compressor system should only be performed by trained operators. Carefully read the
entire Operation section of this manual before attempting to operate the system. Be sure to follow all company policies
and procedures.
Operation of the compressor is controlled with the first button on the B-CAN. The color and text of the button changes
with the current state of operation. The possible states are:
A green ENGAGE COMPR button indicates all safeties have been
met. Press this button to engage the compressor.
A yellow COMPR button indicates not all safeties have been met.
Press this button to display the reason(s) engagement cannot
occur.
A red STOP COMPR button indicates the compressor is currently
engaged. Press this button to disengage the compressor.
A dark grey COMPR LOCKED button indicates the compressor is
locked and service is required. Press this button to display the
service that is needed.
Inspection Prior to Moving Vehicle
At the start of your shift, before taking the vehicle to the job site in the morning, the following inspections should be
performed. This simple one-minute check will help to ensure you don't drive to the job site with an inoperable compres-
sor.
1. With vehicle on a level surface check to ensure the oil level is at least halfway on the sightglass. If not, see
maintenance section for proper filling procedure.
309743
If the system has a generator (GEN) or hydraulic pump (HYD)
installed, the 5th button will be used to control it. Engagement is the
same as for the compressor.
20