Table of Contents
Advertisement
2600-00CTEIGAA
Ver.
ANNEX C. Assembling connector
C.5 N type-male (1/2 in. feeder line)
Below is the method for assembling the N-type-male connector to the 1/2 in. feeder line.
1) The components of the N type-male are an N type-male body, an insert ring, a clamp nut, O-ring, and a
heat shrink tube, and it is assembled using the wire stripper, trimming tool, spanner, etc.
O-Ring
Clamping Nut
2) Using a stripping tool or a knife, strip the 1/2 in. feeder line by 1 in. (25.4 mm) from the end, as shown in
the figure below.
Figure C.8 Assembling the N type-male Connector (1/2 in. Feeder Line) (1)
C-8
4.0
Insert Ring
1 in. (25.4 mm)
Heat Shrink Tube
[1.1 in. (28 mm)]
N type-Male Body
1/2 in. Feeder Line
Trimming Tool
1/2 in. Feeder Line Conductor
1/2 in. Feeder Line Jacket
© SAMSUNG Electronics Co., Ltd.
Advertisement
Table of Contents
