Installing The Blades - Toro 120-7122 Installation Instructions Manual

5
Connecting with the Discharge
Tube
No Parts Required
Procedure
1. Slide the curved end of the discharge tube into the
opening in the bagger top (Figure 14).
2
1
3
4
Figure 14
1. Discharge tube, curved
end
2. Opening in bagger top
3. Discharge tube, flared end
2. Slide the flared end of the discharge tube over the
end of the chute. Move the rubber retaining strap on
the chute snaps over the peg on the discharge tube
to secure it (Figure 14).
G010641
5
4. Peg
5. Rubber strap
6

Installing the Blades

Parts needed for this procedure:
3 Hi-Lift blade
Procedure
1. Remove the existing mower blades installed on your
deck. Refer to the Removing the Blades section in
the Operator's Manual for more information.
2. Install the Hi-Lift mower blades located in loose
parts. Refer to the Installing the Blades section in the
Operator's Manual for more information.
7