Advertisement
Installation
1
Installing the Weight
Parts needed for this procedure:
2
Weight
2
Adhesive bumper
1
Rod
4
Washer
2
Hair pin
Procedure
1. Install an adhesive bumper to the weight (Figure 1).
G016271
5
1. Adhesive bumper
2. Front weight
3. Rod
Note: On Titan MX units, disconnect the front
deck pan from the frame to allow installation of the
weights. Ensure the pan is installed once the weights
are secured.
2. Install the weight to the front of the machine frame.
Secure the weight with a rod, four washers, and two
hair pins as shown in Figure 1.
Note: When installing the front weight allow it to
rest on the front lip of the underside of the machine
frame as shown Figure 2. This will suspend the
weight while you secure it to the machine. Use
care not to dislodge the weight when installing the
supporting rod.
1 2
3
4
Figure 1
4. Hair pin
5. Washer
1
G010701
1. Cutaway of the front of the
machine frame
2. Bumper
Important: Whenever you remove the bagger
attachment, remember to remove the front weight
to return the proper stability to the machine.
2
2
3
4
Figure 2
3. Weight
4. Rest the weight here
during install
Advertisement
