Table of Contents
Advertisement
English
6.1
Mounting the Gearhead
1
1
► Loosen the clamp screws (1) on the gearhead
– do not remove them.
► Apply a mark (with pencil or crayon) at dis‐
tance A (50 mm) from the end of the drive
tube.
2
3
► Push the gearhead (2) onto the drive tube (3)
– turn it back and forth at the same time – until
it reaches or covers the mark on the drive
tube.
Alternative check: The drive tube is correctly
positioned when it completely closes the slot in
the gearhead's clamp (short arrows).
8
A
4
► Line up the center of the gearhead with the
lug (4) on the drive tube – the STIHL logo fac‐
ing up.
► Tighten down the clamp screws on the gear‐
head firmly.
6.2
Fitting the Tines
► Screw the tines (1) by hand into the two
rakes (2) as far as stop – fit all eight tines on
the rakes.
► Tighten down the tines by hand.
6 Assembling the Unit
1
2
0458-417-0121-B
Advertisement
Table of Contents
