Playing Cassette Tapes - Emerson PD6513 Owner's Manual

PLAYING CASSETTE TAPES

1.) Open the cassette door by pressing the STOP
2.) Place a pre-recorded cassette tape into the slots on the inside of the door with
the exposed tape facing up and the full reel on the right side.
3.) Move the FUNCTION selector to the TAPE position.
4.) Press the cassette PLAY
5.) Set the Volume and BASS BOOST controls as desired.
6.) To advance the tape rapidly press the F. FWD
it ends press the STOP
7.) To rewind the tape rapidly press the REW
ends press the STOP
7.) When the tape ends the Automatic Stop System releases the PLAY
shuts off the tape motor. You may then open the cassette door, remove your
tape, turn it over and play the other side if desired.
8.) When you are finished listening, stop the tape, open the door, remove the tape
and close the door. If you are playing a tape and then switch to the RADIO or
CD function be sure to press the STOP
tape mechanism. This prevents excess wear and tear on the mechanism.
IMPORTANT:
Always press the STOP
the cassette door to remove your tape. The Automatic Stop System does not function
in the F. FWD and REW
REW modes the motor continues to run. You must press the STOP
key to shut off the motor before opening the door to remove your tape.
PD6513_D120403.p65
Close cassette door.
key to begin playback.
/EJECT key. .
/EJECT key. .
/EJECT
/EJECT key to shut off the tape motor before opening
modes. When the tape ends in the F. FWD
13
13
/ EJECT key. .
key. To stop the tape before
key. To stop the tape before it
key to disengage the
4/12/2003, 16:17
key and
and
/EJECT