Maintenance; Operation - Makita DCL142 Instruction Manual

5. Place the dust stopper and the paper pack
together into the cleaner cavity in the same direc-
tion of arrow on the dust stopper. Insert them all
the way into the slots in the cleaner cavity.
► Fig.25
6. Place the entire container part of the paper pack
inside the tool itself.
7. Close the front cover completely.
CAUTION:
• Forgetting to install the dust bag or the paper
pack, failure to insert the dust stopper together
with the dust bag or the paper pack all the way
into the slots or using a broken or ripped bag,
may allow dust to get into the motor. This may
result in motor failure.
• Do not fold the cardboard at its opening when
installing the paper pack.
• Never throw away the dust stopper because it
needs to be used repeatedly whenever either
the dust bag or the paper pack is used.
• The paper pack for the cleaner is an important
component for maintaining the tool perfor-
mance. Using other than the genuine paper
pack may cause smokes or ignition.

OPERATION

CAUTION:
• To connect attachments, such as nozzle,
twist-insert attachment in direction of arrow to
ensure secure connection during use. To dis-
connect attachment, twist-extract also in direc-
tion of arrow.
► Fig.26
Cleaning (Suction)
Nozzle
Attach the nozzle to clean off tables, desks, furniture,
etc. Nozzle slips on easily.
► Fig.27: 1. Nozzle
Nozzle + Extension wand (Straight
pipe)
The extension wand fits in between the nozzle and the
cleaner itself. This arrangement is convenient for clean-
ing a floor while standing erect.
► Fig.28: 1. Cleaner body 2. Extension wand
3. Nozzle
Corner nozzle
Fit on the corner nozzle for cleaning corners and crev-
ices of a car or furniture.
► Fig.29: 1. Cleaner body 2. Corner nozzle
Corner nozzle +Extension wand
(Straight pipe)
In tight quarters where the cleaner itself cannot
squeeze in, or in high places hard to reach, use this
arrangement.
► Fig.30: 1. Cleaner body 2. Extension wand
3. Corner nozzle
Cleaning without nozzle
You can pick up powder and dust without nozzle.
► Fig.31

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off
before attempting to perform inspection or
maintenance.
After use
NOTE:
• Putting the cleaner against the wall without any
other support cause the cleaner to fall down and
be damaged.
► Fig.32
Cleaning
► Fig.33
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening, dust bag/paper
pack mounting area and the dust stopper.
CAUTION:
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
► Fig.34
Wash the dust bag in soapy water when it is clogged
with dust and the cleaner power becomes small. Dry it
out thoroughly before use. An insufficiently dried bag
may cause poor suction and shorten the service life of
the motor.
NOTE:
• Paper pack is a throw-away type.
When the sponge filter is clogged with dust, remove it
from the cleaner and then wipe it off or wash in water.
Removing and installing the sponge
filter
► Fig.35: 1. Sponge filter
To remove the sponge filter, remove the dust bag or
paper pack and then pinch and take it out.
► Fig.36: 1. Recessed wall
13 ENGLISH