Jet BMW-1018w Manual

Horizontal bandsaw

Table of Contents

Download this manual

Jet Horizontal Bandsaw

BMW-1018w

Machine Purpose: Cut Metal and Plastics

Must wear safety glasses while operating machine.

Keep. Beware of objects that dangle

and could get caught in cutting tool. Beware of flying metal chips. This machine has no built-in safety

system. Machine auto turns off at lowest height.

Materials: Metals, Plastics, Synthetic

Machine Specs: 10"x18" cutting capacity, 45 deg cut,

Limitations: NO WOOD,

NO SHEET

METAL,

NO MATERIAL UNDER

.5", no pipe

Accessories: Adjustable Depth Stop, Flood Coolant

Blade Dimensions: 1"x130"

Instruction Required: Cold Metals Basic Training

Cold Metals Lab

V1.0 11/7/2017

Table of Contents

Need help?

Do you have a question about the BMW-1018w and is the answer not in the manual?

Page 1 Jet Horizontal Bandsaw BMW-1018w Machine Purpose: Cut Metal and Plastics Must wear safety glasses while operating machine. Safety: Keep. Beware of objects that dangle and could get caught in cutting tool. Beware of flying metal chips. This machine has no built-in safety system.
Page 2 Notes • Never hold a piece smaller then half the vice width in the jaws • If blade is skipping turn down the cutting pressure • Always adjust the blade speed relative to the material being cut • If blade tracking, tension, roller guides or changes are necessary please see shop tech for assistance Prechecks •...
Page 3 To adjust the vise for angle cutting: • Loosen bolts and move vise jaw ( C ) to desired location. • Set the vise to desired angle, re-install nuts and tighten the nut and bolt assemblies. • Adjust the movable vise parallel to the fixed vise by loosening bolt (D) adjusting to parallel, and re-tightening bolt.