Behringer K-2 Quick Start Manual

Analog and semi-modular synthesizer with dual vcos, ring modulator, external signal processor, 16-voice poly chain and eurorack format

Hide thumbs Also See for K-2:

Synthesizers and Samplers

K-2

Analog and Semi-Modular Synthesizer with

Dual VCOs, Ring Modulator, External

Signal Processor, 16-Voice Poly Chain and

Eurorack Format

User Support Bulletin

Introduction

The unit is carefully calibrated at the factory. The performance may change over time or due to environmental changes,

and the following recalibration procedures can be used to bring it back to its factory settings.

Follow all steps in the order in which they are presented.

Make sure your K-2 has been powered on for more than 30 minutes, and that it is in a place where the temperature will

not change drastically while performing the calibration.

Set the K-2 controls as shown.

985-40000-01088 Rev.A

2021-02-03

Confidential, for internal use only. Not to be reproduced.

page 1 of 2

Table of Contents

Do you have a question about the K-2 and is the answer not in the manual?

Page 1 Follow all steps in the order in which they are presented. Make sure your K-2 has been powered on for more than 30 minutes, and that it is in a place where the temperature will not change drastically while performing the calibration.
Page 2 Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Oberheim, Auratone and Coolaudio are trademarks or registered trademarks of Music Tribe Global Brands Ltd.