Behringer K-2 Quick Start Manual page 2

Synthesizers and Samplers
K-2
VCO PITCH Calibration
The K-2 has an internal calibration routine to calibrate the pitch of the VCO.
Press and hold "TRIG SW" while powering up to enter the testing mode. (In this mode, the ON LED will blink yellow).
Press and hold "TRIG SW, " and then set the "FILTER1/2" switch. The ON LED will light yellow, indicating that the
VCO calibration has begun.
Wait until the ON LED changes color:
- Green indicates that the calibration was successful.
- Red indicates calibration failure. If this occurs, turn off the power and repeat from Step1.
Restart the unit.
End of Procedure
Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein.
Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik,
Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Oberheim, Auratone and Coolaudio are trademarks or registered trademarks of Music Tribe Global
Brands Ltd. © Music Tribe Global Brands Ltd. 2021 All rights reserved.
985-40000-01088 Rev.A
Confidential, for internal use only. Not to be reproduced.
2021-02-03
Confidential, for internal use only. Not to be reproduced.
page 2 of 2 page 2 of 2