Setting Up The Remote To Control Your Tv - Dish Network HM-DSR100RU User Manual

S U
ETTING
1. Find the brand name of your TV in the TV code
tables starting on page 32. You will be referring to
this location for codes in the instructions below.
2. Turn on your TV.
3. Press and hold
on (it takes about five seconds).
4. Release
5. Press
6. Enter one of the three-digit codes for your TV from
the TV code tables while
: You have about 20 seconds to begin entering
Note
the TV code.
7. Press the
If
TV
and you can go to step 8. If
at all, the code may not have been entered
correctly. So, start over from step 3 and try the code
again.
8. Press
shuts off, go to step 9. If not, pick another code for
your TV brand from the TV Codes table and go
back to step 3. If you have tried all of the codes and
none work, go to How to Scan for TV and VCR
Codes on page 21.
9. Turn your TV back on by pressing
try the other buttons below to make sure they work.
Press the
•
on your TV.
118866
R
P THE EMOTE TO
.
TV
. Notice
TV
button and watch
MUTE
light flashes three times, the code is valid
and your TV should shut off. If your TV
TV
through
0
C
ONTROL
until both
light will flash.
light turns on and stays on.
TV
light is on.
TV
TV
buttons to change channels
9
Y
OUR
SAT lights turn
TV
light.
TV
light does not flash
again and
TV
TV
7