Troubleshooting Guide - EINHELL GE-ST 36/40 Li E Original Operating Instructions

11. Troubleshooting guide

Fault
The cutter drum
does not rotate
Setting the snow gui-
de blades does not
work (section 6.4.1)
Anl_GE_ST_36_40_Li_E_SPK13.indb 22 Anl_GE_ST_36_40_Li_E_SPK13.indb 22
GB
Possible cause
a) Battery is empty
b) Battery is too cold
c) Snow is too high and is preven-
ting start-up
d) Cutter drum is iced up or full of
snow
e) Insuffi cient contact or no con-
tact between the long handle
and the long handle fastener
(section 5.1)
a) Snow guide blades are iced up
or full of snow
- 22 -
Remedy
a) Replace with full battery
b) Replace with battery at room tempe-
rature
c) Lift the cutter drum a little from the
snow before switching on
d) Carefully free the cutter drum from ice
and snow; let it thaw if necessary
e) Open the long handle connection,
remove the long handle and check the
contacts. Refasten the long handle.
a) Carefully free the snow guide blades
from ice and snow; let them thaw if
necessary
11.06.2021 08:39:54 11.06.2021 08:39:54