Troubleshooting Guide - EINHELL BSF 40 Operating Instructions Manual

Anleitung BSF 40_SPK7:_

13. Troubleshooting guide

Warning: Switch off the engine and pull out the ignition cable before making any checks or adjustments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember that
the exhaust and other parts will get hot. Do not touch these parts as they may burn you.
Fault
The unit does not operate
smoothly and vibrates intensively
The engine does not start
Engine does not run smoothly
Drive power falls
The engine will not start or dies
after a short period of time
Inadequate or no ejection
Snow plow is difficult to push
07.12.2006 13:06 Uhr
Possible causes
- Bolts loose
- Plow unit mounting loose
- Throttle lever in wrong position
- Spark plug defective
- Fuel tank empty
- Petrol cock closed
- Min. oil level
- Air filter dirty
- Spark plug dirty
- Min. oil level
- Clutch play too large
- Automatic oil cut-out active
- Spark plug foul
- No fuel
- Snow ejection unit blocked
- Plow screw not turning
- V-belt torn or loose
- Runner is worn
Seite 19
Remedy
- Check bolts
- Check plow unit mounting
- Check setting
- Replace spark plug
- Top up fuel
- Open petrol cock
- Top up oil
- Clean the air filter
- Clean the spark plug
- Top up oil
- Adjust clutch cable
- Contact authorized customer
service
- Check oil level, top up engine oil
- Clean or replace spark plug
(electrode spacing 0.6 mm)
- Top up fuel
- Clean the snow ejection unit with
a solid object
- Adjust clutch cable.
- Adjust the V-belt tension and
replace shear bolts or contact
authorized customer service
- Contact authorized customer
service
GB
19