Warranty; Technical Specifications - Kärcher K 5 Premium Full Control Plus Instruction Manual

Pressure does not build up in the appliance
 Check setting at the spray lance.
 Check water supply for adequate delivery rate.
 Pull out the sieve in the water connection using flat-
nose pliers and clean under running water.
 Remove air from appliance before operation.
Switch on the appliance without connection the HP
hose (max. 2 minutes) and run it until the water dis-
charging from the HP outlet is free of bubbles.
Switch off appliance and reconnect HP hose.
Strong pressure fluctuations
 Clean high-pressure nozzle: Remove dirt and de-
bris from the nozzle bore, using a needle and rinse
through with water from the front.
 Check water flow quantity.
Appliance is leaking
 Dropwise leakage of the device is normal for tech-
nical reasons. If the leakage increases contact the
authorized customer service.
No detergent infeed
 Turn the 3-in-1 multi jet spray lance to detergent
nozzle "MIX".
 Check whether the Plug 'n' Clean detergent bottle
is placed into the detergent connection facing
down.
No pressure indicator on the trigger gun
 Check / replace the batteries
 Decrease the distance between high-pressure gun
and high-pressure cleaner.
 Couple it to the high-pressure cleaner again.
Error messages
 Switch off the device and pull the
mains plug out of the socket.
 After 20 seconds, insert the power cord
back into the socket and switch the de-
vice on.
If the malfunction occurs repeatedly, have
the device checked by the customer ser-
vice.
Emergency operation
If the pressure regulation on the high-pressure gun is
defective (electronic defect, battery empty, etc.), the
high-pressure cleaner continues operating at the level
that was last set.
To activate emergency operation at the maximum level:
 Switch off the device and pull the mains plug out of
the socket.
 Insert the power cord back into the socket and
switch the device on.

Warranty

The warranty terms published by the relevant sales
company are applicable in each country. We will repair
potential failures of your appliance within the warranty
period free of charge, provided that such failure is
caused by faulty material or defects in manufacturing. In
the event of a warranty claim please contact your dealer
or the nearest authorized Customer Service center.
Please submit the proof of purchase.
Addresses can be found under:
www.kaercher.com/dealersearch
10 English

Technical specifications

Electrical connection
Voltage
Connected load
Type of protection
Protective class
Mains fuse (slow-blow)
Water connection
Max. feed pressure
Max. feed temperature
Min. feed volume
Max. Suction height
Performance data
Working pressure
Max. permissible pressure
Water flow rate
Max. flow rate
Detergent flow rate
Recoil force of the trigger gun
Remote module SRD
Frequency
Transmission power ERP
Dimensions and weights
Length
Width
Height
Typical operating weight
Values determined as per EN 60335-2-79
Hand-arm vibration value
Uncertainty K
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L + Uncertainty
WA
K
WA
Subject to technical changes.
230-240 V
1~50 Hz
2,1 kW
IPX5
I
13 A
1,2 MPa
40 °C
10 l/min
0,5 m
12,5 MPa
14,5 MPa
7,5 l/min
8,3 l/min
0,3 l/min
17 N
868,7-
869,2 MHz
0,53 mW
411 mm
305 mm
584 mm
15,8 kg
0,9 m/s
2
0,6 m/s
2
78 dB(A)
3 dB(A)
94 dB(A)