Removing Rear Wheel - KTM 200 DUKE 2021 Owner's Manual

14.3

Removing rear wheel

–
Clean the thread of the wheel spindle and screw
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Screw, wheel speed
sensor holder
–
Mount and tighten screws
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
–
Take the motorcycle off the front lifting gear. (
B01391-11
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Finishing work
–
Remove the rear of the motorcycle from the lifting gear.
( p. 49)
Preparatory work
–
Raise the motorcycle with the rear lifting gear. (
2
.
M8 25 Nm (18.4 lbf ft)
3
in the hole.
4
.
M6 8 Nm (5.9 lbf ft)
5
.
6
.
M8 15 Nm (11.1 lbf ft)
WHEELS, TIRES 14
2
.
p. 50)
p. 49)
67