Installation; Control Unit , Cu212-1S Connections - Delta DE212 Operation And Installation Manual

2. I
NSTALLATION
2.1 C U , CU212-1S C
ONTROL NIT
The power supply can be 12 or 24VDC, and is connected as described.
See figure below.
PCB
Connections to the
5 Common/GND
4 Deadman handset connection
3 External STOP
1 Deadman override
P1 Output Signals
1 DC-output signal to horn/beeper
2 Warning light signal
(Do not connect)
3 Not in use
4 Deadman output
5 STOP output, normally activated, 12/24V output
(Do not connect)
6 Not in use
7 Minus-pole/GND, for input voltage
8 Plus-pole for input voltage, 12/24V
(Do not connect)
9 Not in use
(Do not connect)
10 Not in use
D RCS AS
ELTA
User and Installation Manual for DE212-1S Wired Deadman
ONNECTIONS
in the control unit.
SW2 see notes below,
chapter 2.2
1 Beeper warning output
2 Warning light
4 Deadman valve
5 E.M. STOP output
7 -
Power input, 12/24VDC
8 +
F1 Fuse 5A
P3 Input Signals
1 Deadman Override
Active at low input, 0V
2 Not in use (Do not connect)
3 External STOP
Active at low input, 0V
4 Deadman cable input (+5V)
5 Deadman cable input (0V)
NOTE: 0V is normally the same
.
Potential as chassis/GND
Document: 02002
Page 4 of 17