SUSPENZ 12-8602 Quick Start Manual

SUP Folding Rack
Tools Needed : Tape Measure, Electric Drill, ¹/₈" Drill Bit, #2 Phillips
Head Driver, Stud Finder
The length of your SUP will determine arm spacing.
is 40% of total SUP length, (SUP length x 0.4 = spacing).
Locate studs where arms will be mounted and mark desired height
SUP Folding Rack
for the
bracket
as a template, and a
for holes. Wall studs are typically on 16" centers. It is important that
at least one screw from each
Screwing only into drywall is not sufficient and could result in
stud.
injury to self and SUP.
1. Pre-drill pilot hole for
The second hole will typically miss a single stud (see Photo #1).
2.
plastic anchor
Insert a
hit a stud on both holes, skip this step.
Pro Tip: An old woodworkers trick is to rub the screw
threads on a bar of soap for easy installation.
(continued next page)
For Technical assistance or Replacement parts: call 866.787.7369
Rev. 8/19
®
Suspenz products are warrantied for life against defects in material or workmanship to the original owner. Product must
be used for its intended purpose under normal conditions. Please visit www.Suspenz.com for complete warranty
information.
Suspenz®, Inc.
8725 Roswell Road #0-220
Atlanta GA 30350
at base of support arm. Use a
mounting screw
to mark the locations
mounting bracket
goes into a wood
Phillips Head screw
using a ¹/₈" drill bit.
If you were lucky and
into the hole. Note:
OUR PLEDGE TO YOU
Scan* to see
Video Instructions
for Assembly & Use
*QR code reader app required
Holds up to 75 LBS
mounting
Model # 12-8602
Parts List
Qty Name
2 SUP Folding Rack—Yellow
8 Plastic Mounting Bracket
8 Mounting Screw
4 Plastic Anchor
4 Wall Extension Plates
Photo #1
Customer Service:770-518-0045
Fax: 770-518-8507
Website: www.suspenz.com
P. 1