Backplane Jumper Settings - Dell POWEREDGE C6105 Hardware Owner's Manual

Table 5-1. System Configuration Jumper
Jumper Function
JP4 Clear Password
JP3 BIOS Recovery
J5 COM Port Switch**
JP9 Clear CMOS
JP1 BMC Configuration
NOTE: The * in the table of system configuration jumper describes the default
status and the default state is not active state.
NOTE: ** means if disabled, BMC Port 1 is set to internal and port 2 to external; if
enabled, BMC Port 1 is set to external, and internal port has no function.

Backplane Jumper Settings

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
The function of jumpers installed on 3.5" backplane and 2.5" backplane is
the same. Following is an example using the jumpers installed on 3.5"
backplane.
Off
*Disable
*Disable
*Disable
*Disable
*Disable
Jumpers and Connectors | 159
On
Enable
Enable
Enable
Enable
Enable