Dell POWEREDGE C6105 Hardware Owner's Manual page 27

Error Code Error Message
4108 Dram ECC requested but not enabled
4109 Online spare requested but not enabled
410A DIMM(s) Running in Minimum Mode
410B No DQS Receiver Enable pass window found
410C DQS Rcvr En pass window CHA to CH B too large Pause
410D DQS Rcvr En pass window too small (far right of
dynamic range)
4160 The processor(s) installed in your system are not
multiprocessing capable.
5120 CMOS cleared by jumper
5121 Password cleared by jumper
8101 Warning! USB Host Controller not found at the
specified address!!!
8102 Error! USB device failed to initialize!!!
8103 Warning! Unsupported UBS device found and
disabled!!!
8104 Warning! Port 60h/64h emulation is not supported
by this USB Host Controller!!!
8105 Warning! EHCI controller disabled. It requires
64bit data support in the BIOS.
8400 Warning!! Insufficient memory! Remote access is
disabled.
8601 Error: BMC Not Responding
8701 Insufficient Runtime space for MPS data!!
System may operate in PIC or Non-MPS mode.
Response
Pause
Pause
Pause
Pause
Pause
halt
Pause
Pause
Warning
Warning
Warning
Warning
Pause
Warning
Pause
Pause
About Your System | 27