AudioCodes Mediant 500Li Quick Setup Manual page 7

2. Make sure that your computer is configured to automatically obtain an IP address. The device has an
embedded DHCP server, which by default, allocates IP addresses to connected computers.
3. On your computer, start a Web browser and in the URL address field, enter the device's default IP
address; the Web interface's Web Login screen appears:
4. In the 'Username' and 'Password' fields, enter the case-sensitive, default login username (Admin) and
password (Admin).
5. Click Log In.
Configuring LAN and WAN
This section describes how to configure the device's LAN and WAN interfaces.
After accessing the device through the LAN interface, you can configure Web management access from one of
the following interfaces:
Any of the configured Voice Gateway LAN interfaces.

WAN port interface: In this setup, you need to enable remote access to the WAN port interface.

For basic configuration, click
Modifying LAN Interface
The device's default LAN IP address is 192.168.0.1/24. You can change this to suit your networking scheme.
By default, the device's embedded DHCP server is enabled for the LAN, and with default IP pool addresses
relating to the default subnet LAN. You can disable the DHCP server or modify the IP address pool. The
DHCP server allocates this pool of IP addresses to the computers connected to its LAN interface.
1. Open the LAN Interface page (Setup menu > IP NETWORK tab > CORE ENTITIES folder > LAN Interface).
2. Configure the following:
LAN Interfaces

DHCP (enable / disable)

DNS

here to view the configuration note.
7 | P a g e