Operation; Fuels - ProFitter KFA50PF Operating Instructions & Parts Manual

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
ProFitter Operating Instructions and Parts Manual
TM
Models KFA50PF, KFA75PF, KFA125PF,
KFA170PF and KFA210PF
Assembly (Continued)
FOR MODELS KFA50PF AND
KFA75PF ONLY
TOOLS REQUIRED
- Medium Phillips screwdriver.
1. Lift front guard for arrow direction
and make sure that guard's wedged
portion fits into the slit hole on the
upper housing.
2. Remove the pre-assembled screws on
the shell upper and side cover.
3. Align the holes in upper housing
withtwo mounting holes on the
handle asshown in Figure 7.
4. Secure handle with the screws
removed.
5. Insert cord wrap into the rectangle
holes on the supporter and align the
hole on the cord wrap with the
mounting hole on the side cover as
shown in Figure 7.
6. Secure cord wrap with
removed.
Screw
Handle
Remove Screws
Remove Screws
Side Cover
Screw
Figure 7 – Handle and Cord Wrap
Installation KFA50PF and
KFA75PF only
FOR MODELS KFA125PF, KFA170PF
AND KFA210PF ONLY
TOOLS REQUIRED
- Medium Phillips Screwdriver.
- 3/4 inch socket or adjustable wrench
Assembling Handle & Wheel and
Cord Wrap
1. Slide threaded axle through the rear
sectioon of the wheel support frame.
For Technical Support or Troubleshooting, Call: 1-877-447-4768, 8:30 am - 4:30 pm CST www.ghpgroupinc.com
Front Handle
Hot Air Outlet
Fuel Tank Flange
Wheel Support
Cap Nut L
the screws
Figure 8 – Models KFA125PF, KFA170PF and KFA210PF Assembly
Front Guard
2. Slide one axle bushing on to each side
Wedged
of the axle. Slide one wheel on to each
Portion
side of the axle. Attach one cap nut on
Slit Hole
Shell Upper
to each side of the threaded axle and
tighten well.
3. Place heater on wheel support frame.
Cord Wrap
Align the holes on fuel tank flange
with holes on wheel support frame.
4. Position the Handles on top of fuel
tank flange.
Insert screws through handles, fuel
tank flange and wheel support frames
as shown in Figure 8 and attach nut
finger tight after each screw is inserted.
5. Align the hole on the handles with the
mounting hole on the Cord Wrap.
Insert Screws through Cord Wrap,
handles and attach nut finger tight
after each screw is inserted.
6. After all screws are inserted, tighten
nuts firmly.
Frame
Nut
Wheel
5
Screw
Cord Wrap
Rear Handle
Cap Nut S
Air Inlet
Threaded Axle
Wheel Bushing
Do not operate
CAUTION
heater without
support frame fully assembled to tank.

FUELS

For optimal performance of this heater,
it is strongly suggested that 1-K kero -
sene be used. 1-K kerosene has been
refined to virtually eliminate contami -
nants, such as sulfur, which can cause a
rotten egg odor during the operation
of the heater. However, #1/#2 diesel/fuel
oil, JET A or JP-8 fuels may also be used if
1-K kerosene is not available. Be advised
that these fuels do not burn as clean as
1-k kerosene, and care should be taken
to provide more fresh air ventilation to
accommodate any added contaminants
Flange Screw