Operation; Connecting The Ac Cord; How To Store The Remote Controller; Setting The Unit For Remote Operation - Daewoo DSB-122L Owner's Manual

DSB-122L/122LH(영어) 01.8.17 5:27 PM 페이지9

CONNECTING THE AC CORD

The outdoor unit is connected to the indoor unit through the AC connecting wire or connection cord. To connect the in-
door unit to AC, follow the procedures below:
1. Insert the at-
tached AC plug
AC Outlet
into a pronged
and Plug
220V AC outlet.

HOW TO STORE THE REMOTE CONTROLLER

To store the remote controller, follow the procedures below:
1. Remove the left and right side to open the indoor
cover upward.
• Please remove and insert
• the indoor cover by two hands.
3. Press the left and right side to close the indoor cover.

SETTING THE UNIT FOR REMOTE OPERATION

After the unit is fully connected and plugged in, it can be turned on. To turn the unit on and set it for remote operation,
follow the procedures below:
1. Open the indoor unit's cover and make sure the
EMERGENCY/REMOTE switch is set to the REMOTE
position; this will allow the unit to operate with the re-
mote controller.

OPERATION

Plug into 220V AC Outlet.
EMERGENCY/REMOTE Switch
EMERGENCY REMOTE
NOTES:
• Never connect the AC line cord plug to other than the
specified voltage (220V).
• Use the attached power cord only.
• The new air conditioner system should be on it's own
220V circuit. Contact your local electrical installer for in-
stallation.
2. Store the remote controller.
2. Press the ON/OFF button on the remote controller to
turn on the unit. The On LED will light on the indoor
unit and "ON" will light in the remote display.
To select the various modes
and settings, read the fol-
lowing pages.
THREE MINUTE COMPRESSOR DELAY
• After turning the indoor unit on and setting it for air con-
ditioner operation, the compressor (outdoor unit) will
not come on for three minutes. This is a feature that
will protect the compressor from damage due to quick
start and stops.
9
(Remove it when using)