Related Manuals for SUN RUN SPE-2
Summary of Contents for SUN RUN SPE-2
- Page 1 CHU LUN SING CO.,LTD No.199, Gangshan N. Rd., Gangshan Dist., Kaohsiung City 82059, Taiwan http://www.sunrun.com.tw E-mail:sun.run@msa.hinet.net TEL:886-7-6210505 FAX:886-7-6217575 SPE-2 SPE-5 C1~C7 English Ver.19...
- Page 2 700 bar(10,000psi) .. ) 65 C(150 F) 700 bar (10,000psi)
- Page 3 SUN RUN SUN RUN SUN RUN SUN RUN...
- Page 4 60=60L(15.8gal) 420mm 35mm 370mm SPE-2153202 Model Operation Flow Rate Pressure DBA at Weight Number Rating Idle and ( 20Lreservoir has no oil) 700bar (L/min) (bar) (kg) 1 stage 2 stage 1 stage 2 stage Two-stage 70-79 55.5 1725 SPE-2 10.5...
- Page 5 Custom build your Electric Pump: SPE- 5 4 CW Circuits Used with cylinder Valve Function A A B B BASIC PUMP VALVE 5=5Hp(3.7kw) 2=230V 3=380V Manual 3 way Valve 3.Hz 5=50Hz Manual 4 way Valve 6=60Hz 3=3ph (Lx0.26=gal) 20=20L(5.2gal) 40=40L(10.5gal) 60=60L(15.8gal) 541.70 541.70...
- Page 6 0-10,000psi (700 bar) (1/4"NPT) 3/8-18NPTF 1/4"NPT CHU LUN SING CO.,LTD TEL:886-7-6210505 FAX:886-7-6217575 http://www.sunrun.com.tw E-mail:sun.run@msa.hinet.net No.199, Gangshan N. Rd., Gangshan Dist., Kaohsiung City 82059, Taiwan PE-XXXXXX P031211001-21...
- Page 7 Release 1/4"NPT Before using, please release air vent screw to prevent vacuum damage. & Oil & air vent ( 4.1) ( 4.2) "A"; "B" "A" "B" "B" "A" ( 4.3) "UP" "DOWN" "DOWN" ( 4.4) Take out outside hexagonal bolt Low pressure High pressure DOWN...
- Page 8 1/2" (1cm) SUN RUN 1/2 inch (1cm) " " 1~2 SUN RUN...
- Page 9 CHU LUN SING CO.,LTD No.199, Gangshan N. Rd., Gangshan Dist., Kaohsiung City 82059, Taiwan http://www.sunrun.com.tw E-mail:sun.run@msa.hinet.net TEL:886-7-6210505 FAX:886-7-6217575 OPERATING INSTRUCTIONS HYDRAULIC ELECTRIC PUMP SPE-2 SPE-5 English E1~E7 English Ver.19...
-
Page 10: Safety Precautions
Install SUN RUN equipment. The operator is pressure gauges in the system to monitor responsible for this activity towards other operating pressure. - Page 11 Always use a saddle to protect the plunger. WARNING: Immediately replace worn or damaged parts with genuine SUN RUN parts. SUN RUN parts are designed to fit properly and withstand rated loads. IMPORTANT: Hydraulic equipment must only be serviced by a qualified hydraulic technician.
-
Page 12: Specifications
Instructions for: Model:SPE-2 Hydraulic Electric Pump 2. SPECIFICATIONS Custom build your Electric Pump: SPE- 2 3 CW Circuits 1.Motor Used with cylinder Valve Function A A B B 2=2Hp(1.5kw) 2 .Voltage BASIC PUMP VALVE 2=230V 3=380V 3.Hz 5=50Hz Manual 3 way Valve... - Page 13 Instructions for: Model:SPE-5 Hydraulic Electric Pump 2. SPECIFICATIONS Custom build your Electric Pump: SPE- 5 Circuits Used with cylinder Valve Function 1.Motor A A B B 5=5Hp(3.7kw) BASIC PUMP VALVE 2 .Voltage 2=230V 3=380V 3.Hz Manual 3 way Valve 5=50Hz 6=60Hz Manual 4 way Valve 4.Phase...
-
Page 14: Installation
Instructions for: Model:SPE-2 Hydraulic Electric Pump SPE-5 3.INSTALLATION Hydraulic Connect Use 1-1/2 wraps of teflon tape (or suitable thread sealant) on all threads, leaving the first complete thread free of tape to ensure that the tape does not shed into the hydraulic system, causing damage. Trim loose end. -
Page 15: Operation
Instructions for: Model:SPE-2 Hydraulic Electric Pump SPE-5 4. OPERATION NOTE: To avoid power losses between the electrical outlet and pump motor, use the shortest possible extension cord. The pump motor will function at low voltage, but motor speed and oil flow will be reduced. -
Page 16: Troubleshooting Guide
Check reservoir hydraulic oil level every 40 hours of operation. Add oil when necessary to bring the level to 1/2" (1cm) below the fill opening. Use only SUN RUN hydraulic oil. The use of other oils or fluids may damage your system, and will void your SUN RUN warranty.
Need help?
Do you have a question about the SPE-2 and is the answer not in the manual?
Questions and answers