Table of Contents
Advertisement
Adding a NAT/Route Int -> Ext policy
Adding Transparent mode policies
Add Transparent mode policies to control the network traffic that is allowed to pass through the firewall when
you are running the it in Transparent mode.
•
Go to Firewall > Policy .
•
Select a policy list tab.
•
Select New to add a new policy.
You can also select Insert Policy before
specific policy.
•
Configure the policy:
Select an address or address group that matches the source address of the packet. Before you
Source
can add this address to a policy, you must add it to the source interface. To add an address, see
Addresses.
Select an address or address group that matches the destination address of the packet. Before
Destination
you can add this address to a policy, you must add it to the source interface. To add an address,
see Addresses.
A schedule that controls when this policy is available to be matched with connections. See
Schedule
Schedules.
A service that matches the service (port number) of the packet. You can select from a wide range
Service
of predefined services, or add custom services and service groups. See Services.
DFL-500 User Manual
on a policy in the list to add the new policy above a
27
Advertisement
Table of Contents
