Data bits
Parity
Stop bits
Flow control
•
Press Enter to connect to the DFL-500 CLI.
The following prompt appears:
DFL-500 login:
•
Type admin and press Enter.
The following prompt appears:
Type ? for a list of commands.
For information on how to use the CLI, see the DFL-500 CLI Reference Guide .
Next steps
Now that your DFL-500 NPG is up and running, you can proceed to configure it for operation:
•
If you are going to run your DFL-500 NPG in NAT/Route mode, go to
•
If you are going to run your DFL-500 NPG in Transparent mode, go to
DFL-500 User Manual
8
None
1
None
NAT/Route mode
installation.
Transparent mode
installation.
14