Table of Contents
Advertisement
3. After that, turn off DC power supply (9V) to the jig, unplug AC adaptor,
and remove pins on PCB.
Then close the cabinet. The base pin returns to the default (0000) and
you can register a handset to the base using the base PIN (0000).
6.4. Reset
6.4.1. Base Unit
If the base unit is reset, the Caller ID list will clear.
- To exit the operation, press
- *1: The factory preset is 0000.
Base Unit Initial Settings
Function
Ringer Mode
Number of Rings
Recall Time
Pause Timing
Call Restricted Handsets
Call Restriction Numbers
4-Digit Base Unit PIN
6.4.2. Handset
You can reset all of the handset settings to their initial settings.
any time.
Initial Setting
All Handsets
3
100 msec
3 seconds
All Clear
All Clear
0000
12
Remarks (selectable options
All Handsets/Specific Handset N
Up to 6 rings
100 msec/ 700 msec
3 seconds/5 seconds
Each Handset can be set
indivisually.
Up to 10 numbers (up to 8 digits
-
Advertisement
Table of Contents
