Cub Cadet 928 SWE Operator's Manual page 13

Two-Way Chute Control™
The two-way chute control is located on the left side of the dash
panel and is used to control the distance of snow discharge from
the chute.
• To change the upper chute angle to control the distance
that snow is thrown, pivot the lever forward or backward.
• Move the lever forward to pivot the upper chute down and
reduce the distance snow is thrown.
CHUTE DIRECTIONAL CONTROL
DISCHARGE DISCHARGE
RIGHT
LEFT
• Move the lever rearward to pivot the upper chute upward
and increase the distance snow is thrown
Chute Directional Control
The chute directional control is located on the left side of the
snow thrower.
• To change the direction in which snow is thrown, crank
clockwise to discharge to the left and counterclockwise to
discharge to the right.
Wheel Steering Controls
The left and right wheel steering controls are located on the
underside of the handles. Squeeze the right control to turn right;
squeeze the left control to turn left.
NOTE: Operate the snow thrower in open areas until you are
familiar with these controls.
Chute Clean-Out Tool
CONTROL DIRECCIONAL DEL CANAL
The chute clean-out tool is conveniently fastened to the rear of
DESCARGA A
the auger housing with a mounting clip. Should snow and ice
LA IZQUIERDA
become lodged in the chute assembly during operation, proceed
CHUTE TILT
DOWN
as follows to safely clean the chute assembly and chute opening:
1. Release both the Auger Control and the Drive Control.
2. Stop the engine by removing the ignition key.
3. Remove the clean-out tool from the clip which secures it to
the rear of the auger housing.
CHUTE TILT
UP
4. Use the shovel-shaped end of the clean-out tool to
dislodge and scoop any snow and ice which has formed in
and near the chute assembly.
5. Refasten the clean-out tool to the mounting clip on the
rear of the auger housing, reinsert the ignition key and
start the snow thrower's engine.
6. While standing in the operator's position (behind the snow
thrower), engage the auger control for a few seconds to
clear any remaining snow and ice from the chute assembly.
Head Light
It can be tilted by loosening the screws on the side of its housing,
position the light in the desired location and then retighten the
screws.
WARNING!
Never use your hands to clear a
clogged chute assembly. Shut off engine and remain
behind handles until all moving parts have stopped
before unclogging.
DESCARGA
A LA
DERECHA
s 4 — c
ectiOn OntrOls and
INCLINACIÓN DEL
CANAL HACIA
ABAJO
INCLINACIÓN DEL
CANAL HACIA ARRIBA
f 13
eatures