Operating Conditions - Bosch SCD110 Quick Start Manual

Device specifications
f Intended use
f Dimensions (L x W x H)
f Weight
f Power supply
▶ Battery life
▶ Enclosure protection class
▶ Electrical protection class
▶ Memory capacity
f BLE activation
f Country certifications
f Environmental certifications

OPERATING CONDITIONS

f Environments
f Operating temperature range -20 °C ... +85 °C
f Recommended storage
temperature
f Humidity range
ACCURACY
f Temperature
f Acceleration
f Magnetometer
f Light
Note: specified accuracies refer to the inbuilt sensors. The accuracy and responsive-
ness of the SCD110 might deviate from sensor specifications dependent on installa-
tion conditions and environmental influences.
RESOLUTION
f Temperature
f Acceleration
f Magnetometer
f Light
COMMUNICATION
f Frequency range
f Tx Power
f Bluetooth Low Energy
f Range
Note: SCD110 uses BLE 4.2 "Just Works" connectivity. This technology cannot pre-
vent from Eavesdropping/Sniffing the connection, cloning the device or taking over
the connection, what can affect SCD data integrity.
To avoid the risk of the aforementioned attacks the user shall ensure that the envi-
ronment within the range of the BLE connection SCD is secure.
Disposal according to the WEEE Directive 2012/19/EU
The unit, accessories, and packaging should be sorted for envi-
ronmental-friendly recycling. Do not dispose of the device into
household or industrial waste! According to the European Guide-
line 2012/19/EU, electric and electronic devices that are no longer usable must
be collected separately and disposed of in an environmentally correct manner.
Monitoring of conditions. Integration of the
SCD110 in machine controls is forbidden and
waives the CE conformity.
71 mm x 62 mm x 10.5 mm
21 g
Non-rechargeable CR2450 3 V
Li/MnO2, 490 mAh
up to 2 years depending on configuration
and use
IP 67
III
1 MB
Standby: On push of button
In operation: Every 3 hours
CE, USA, Canada - for other countries ask the
BCDS support
RoHS, REACH
Residential, commercial, light-industrial, and
industrial
+10°C ... +30°C
0 % RH ... 100 % RH
±0.25°C
up to ±200g ±10%
up to ±1300 uT (X,Y-Axis);
±2500 uT (Z-Axis) ±5%
0 ... 188000 Lux ±15%
0.1 °C
0.1 g
10 uT
1 lux
2400 ... 2483.5 MHz
7 dBm max
up to 40 m (dependent on external influences)
4
Declaration of conformity:
Bosch Connected Devices and Solutions GmbH hereby declares that the radio
equipment type SCD110 complies with Radio Equipment Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following Internet
address: https://www.bosch-connectivity.com/products/sense-connect-detect
Federal Communications Commission (FCC) Notice
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause unde-
sired operation.
The manufacturer is not responsible for any changes or modifications not
expressly approved by the party responsible for compliance. Such modifica-
tions may void the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a res-
idential installation. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
f Reorient or relocate the receiving antenna.
f Increase the separation between the equipment and receiver.
f Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
f Consult the dealer or an experienced radio/TV technician for help.
ISED Canada (IC) Notice
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference,
including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
Bosch Connected Devices and Solutions GmbH
Ludwig-Erhard-Straße 2
72760 Reutlingen
Germany
www.bosch-connectivity.com
5