Advertisement
3.0 APPLIANCE DATA - CONTINUED
Contact details
Focal Point Fires Ltd, Avon Trading Park, Christchurch Dorset, BH23 2BT
4.0 UNPACKING THE APPLIANCE
Read all the instructions before continuing to unpack or install this appliance. Carefully lift the appliance from the carton. Check
that the contents correlate with the component checklist below. Please dispose of all packaging with care at your local recycling
5.0 COMPONENT CHECKLIST
centre.
QUANTITY
1
6.0 OPERATING THE APPLIANCE
1
Check that the fan outlet is not covered or obstructed in any way, and ensure the power to the fire is switched on.
The appliance controls are concealed behind a front panel above the heater.
'T'
Thermostat control knob
'1'
ON/ OFF Power Switch
'2'
Heater switch (1000W)
'3'
Heater switch (1000W)
Switch '1' controls the power to the appliance. The flame effect can be operated with or without the heater. With the power
switch on, switch '2' turns on heat setting 1 (1000W), and switch ''3' controls heat setting 2 (2000W). The power switch must be
switched on for the heat settings to work. The appliance is fitted with a thermostat. To adjust the thermostat, turn knob 'T' until
the desired room temperature is achieved.
Note: The thermostat must be set to a higher temperature than the room temperature for the heater to
operate.
7.0 SAFETY CUTOUT SYSTEM
This product has one non-self-resetting overheat protection device (thermal cut-out) which will activate if the air inlets or out-
lets are obstructed. For safety reasons the fire will NOT switch on again automatically, the following procedure must be carried
out before the fire can be operated.
NOTE: The visual effect will remain operational if the cutout is activated, only the fan heater is prevented from working.
Switch OFF the appliance at the wall socket or outlet. Leave the fire OFF for a period of no less than 10 minutes, ensuring all
obstructions are removed. Switch the appliance ON at the wall. Ensure the appliance is turned ON at the control switches. If
the fire fails to operate correctly, repeat the above procedure. If an attempt to switch on the appliance is made before the safe-
ty cutout has reset, the appliance may cutout for a further period of time. If the sequence has been followed correctly and the
appliance still fails to function, check the fuse in the wall outlet. If this is not the cause, call an electrician or maintenance engineer.
DESCRIPTION
Stove and heater assembly
User instruction booklet
Other control options
Room temperature control with
presence detection
Room temperature control with
open window detection
With distance control option
With adaptive start control
With working time limitation
With black bulb sensor
4
GB IE
No
No
No
No
No
No
©
2021 Focal Point Fires Ltd.
Advertisement
