Page 1
Assembly Instructions Headline Ibiza Electric Wall/Ceiling Mounted Heater - 2000W KLEH163-0600C IMPORTANT PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE. THIS IS IMPORTANT INFORMATION REGARDING THE USE AND CARE OF YOUR OUTDOOR HEATER. ASSEMBLY PERSONS TIME REQUIRED Nov 2021...
Page 2
Important Information Unpack the outdoor heater making sure that all of the items are present and that there are no components left in the box and the heater head is free from any packaging material. Extra packaging is added to some models for transportation protection which must be removed before assembly.
For Your Safety Warning Caution • This heater is not equipped with a device • Some parts of this product can become DO NOT to control the room temperature. very hot and cause burns. Particular use this heater in small rooms when they attention must be given where children, are occupied by persons not capable of vulnerable people and animals are...
Page 4
For Your Safety 11. The marking concerning covering should DO NOT attempt to repair or adjust any be visible after the heater has been electrical or mechanical functions on this installed. It shall not be placed on the unit. Doing so will void your warranty. back of portable heaters.
Page 5
For Your Safety DO NOT 38. One dark point may exist on the surface insert or allow foreign objects to enter any ventilation or exhaust opening of the heating elements during the as this may cause an electric shock or fire, first few minutes after it is turned on.
Installation min. 25cm M6x10 Screw min. 15cm 180cm FLOOR Installation to Wall When using the heater, please carefully follow the instructions and recommendations below. • When fixing the heater to a wall, ensure • You could loosen the two M6*10 screws by hinges are in the underside so that the lid the ‘L’...
Page 7
Assembly to Wall Parts Name Expanding bolt M6*50 M6 spanner ‘L’ hexagonal wrench(4mm) Remote control • Step 1: put 4 x expanding bolts M6*50 into the wall.
Page 8
Assembly to Wall • Step 2: Take off the nuts, the spring locks washers and the plain washers from four expanding bolts. Keep them for the next step. • Step 3: Install the heater on the wall...
Page 10
Assembly to Ceiling Parts Name Hanging Cable • Step 1: Attach the hanging screw on the hanging cable component into the screw holes on the back of the product and secure in place tightly.
Page 11
Assembly to Ceiling • Step 1: Hang the product from a secure ceiling. CEILING Finished...
Operation Instructions Connect the power cable to a 13 amp supply which is located in a safe, dry area. The switch on the heater is used to control the Heater. When the position mean on the , the standby light will be turn orange, the heater will be in standby mode.
Operation Instructions Trouble Shooting Technical specification • Power supply 220V-240V 50Hz If the heater will not operate, please check the following before seeking repair of service: • Wattage max 2000W • Check if the power cord is plugged into an •...
Page 14
Maintenance and Care Instructions Headline • Unplug the unit and let it cool completely. • When disconnected from the electrical supply, clean the outside of the patio heater with a damp cloth. Never use corrosive or solvent cleaners or immerse in water. •...