Switch Source - Feelworld L2 PLUS User Manual

Note: When using chroma key, make sure that the layer you want to edit is on the top layer, which is the B
layer in the PIP setting, otherwise you may not see the chromakey effect.

3.4 Switch Source

When you access the four source buttons, the lights on the source buttons will appear in four
states:
green constant: the signal is recognized, no action is being taken;
green flashing: the currently selected, signal is being edited;
red constant: the signal is currently on the main output;
unlit: the source is not accessed or the resolution of the accessed source is not supported by the L2
PLUS
After transition effect (MIX) and transition mode (MODE) is selected
In FAST+Time Mode:
1. Press a source button (1, 2, 3, or 4) that is green.
2. Selected source will be switched to the output with the set fade TIME and using the MIX
transition selected, with the pressed source button becoming red.
Slide the T-BAR to switch
1. Press a source button (1, 2, 3, or 4) that is green.
2. Slide T-Bar from top end to bottom end or reversely.
Note: Source selection is locked when T-BAR is in transition (not entirely docked at a top or bottom position)
16