Static Direct Connection - Feelworld L2 PLUS User Manual

Steps to modify the IP address of the Ethernet port (windows).
1. Open the "Network and Sharing Center";
2. Click on "Internet";
3. Access to Properties may require administrator
privileges;
4. Under "This connection uses the following
items", find "Internet Protocol version 4
(TCP/IPv4)";
5. Select "Use the following IP address" and
change the IP address to the same network
segment as L2 PLUS, eg: L2 PLUS's IP address is
192.168.0.99, then the computer's IP address can
be set to 192.168.0.1-255. Please make sure that
the IP addresses do not conflict.
6. Click "Subnet Mask" and the computer will
automatically calculate the subnet mask of the
address;
7. Click OK.

5.1.2 Static Direct Connection

To ensure that Feelworld Live can connect in different classes of subnet masks, if you find that you
cannot connect to the L2 PLUS series by searching, please try to use the direct connection method.
The direct connection feature was added after Feelworld Live was updated to version V1.0.0.9.
24