Step 3. Initial Pump & Engine Preparation - North Star M157115C.2 Owner's Manual

Prepare Verify pump oil level.
Water Pump Note: The pump is shipped with oil.
1. Remove shipping tape and black vent plug
(if present) from oil fill cap.
2. Verify that oil level is halfway up the
sight glass.
3. If oil level is low, fill using SAE 30 non-detergent oil or Cat Pump Oil Item # 22158.
Prepare Fill the engine with oil.
Engine Note: The engine is shipped without oil.
Refer to the Engine Manual to locate oil-fill port and for instructions on filling. Use the oil
grade and quantity specified in the Engine manual. Note: Engine is equipped with an Oil
Drain Hose. To account for the volume of the Drain Hose, an additional ounce of oil will
need to be added to the quantity specified in the Engine Manual.
Assembly and Initial Set-Up
STEP 3. INITIAL PUMP & ENGINE PREPARATION
OIL SIGHT GLASS
Fig157115_14
13
OIL CAP
PLUG
DRAIN HOSE