Trim Rod Installation - BRP EVINRUDE E-TEC 200 Service Manual

TRIM AND TILT
TRIM AND TILT SERVICE
removed later for the Pressure Leak down Test
on p. 341.
Install the re servoir f ilter screen in the cylin der
body. Make sure that the screen is seate d. Use a
6 mm Allen wrench to install the plug. Tighten the
plug securely.
Lubricate and place a new rese rvoir O-ring in the
cylinder body.
1
1. O-ring
358
Attach the reservoir to the cylinder body with three
Pozidriv screws. Tighten the screws to a torque of
35 to 52 in. lbs. (4.0 to 5.9 N·m).
41851

Trim Rod Installation

Lubricate th e trim
assemblies in to the bo dy. Push the m in until the
end cap s just clea r the top s o f the cylinders. Fill
the cylinders with Power Trim/Tilt & Steering Fluid.
Failure to fill the cylinders could cause difficulty in
purging air from the unit.
41863
Screw the trim rod end caps into the cylinder body.
Use Trim Cylin der End Cap Remover/In staller,
P/N 436710, o r Universal S
41865
rod pistons. Place the r od
panner W rench,
41866
41867