Oil Control Settings; Oil Injection Rate - BRP EVINRUDE E-TEC 200 Service Manual

OILING SYSTEM

OIL CONTROL SETTINGS

Check valves pre ssed into the cra nkcase b elow
#4 and #6 ree d valve assemblies connect to
hoses which route to a
block, above #2 cylinder.
1
2
1. Lower to upper main bearing oiling circuit
2. Idle oil circuit
3. Tee fitting
4. Cylinder recirculation circuit
Crankcase / Main Bearing Recirculation
The movement of oil through the main bearings is
controlled b y in ternal p assages, exter nal fitting s
and hoses, and an in-line check valve.
Both cent er ma in be arings receive oil throu gh
grooved passages in th e crankcase. Oil migrate s
to the bearings from th e crankcase a reas of the
higher cylinders.
The lower main bearin g receives oil thro ugh a
grooved passage in the crankcase.
Lower to upper main bearing oil flow
Oil moves from the lower main b earing cavi ty
through an internal cran kcase p assage to an
external fitting. Ext ernal hoses with an
check valve connect to a f itting at the upper main
bearing, which leads to t he up per main bearing
through an internal crankcase passage.
168
fitting at the top of the
005043
in-line
OIL CONTROL SETTINGS

Oil Injection Rate

The Engine Management Module (EMM) controls
the oil in jection rate based on engine RPM. This
3
rate can be adjusted for the type of oil being used,
and also for powerhea d break-in. Use Evinrude
Diagnostics software to access these features.
The Set Oil Type option controls the injection rate
4
for the oil being used and typical operating condi-
tions.
The TC-W3 oil type setting is the standard setting
for all outboards. Set TC-W3 for:
•
Operation with a ll TC-W3 outboard o ils in clud-
ing XD30, XD50, or XD100.
•
Applications requiring maximum lubrication.
•
Extreme applications (commercial or harsh con-
ditions, racing or other high performance opera-
tion).
•
Use this set ting with XD100 outb oard oil in
extreme applications
The XD100 setting provides an option to run the
outboard at a reduced oil injection rate. This set-
ting REQUIRES the use of Evinrude XD100 ou t-
board lubrican t and is not recommend ed for all
applications.
IMPORTANT:
able on all models.
Use the XD100 setting for:
•
Conventional use (runabouts, cruisers)
•
Moderate applications
1. Oil control setting
The XD100 setting is not avail-
1
008571