Dynamic Tests - BRP EVINRUDE E-TEC 200 Service Manual

ENGINE MANAGEMENT MODULE (EMM)
DIAGNOSTIC SOFTWARE FUNCTIONS
Ignition Test
Use the d iagnostics software to test each ignition
circuit. Refer to Static Ignition Test on p. 82.
Fuel Test
Use the diagnostics software to t est each fu el
injector circuit. Refer to Fuel Injector Static Test
on p. 85.
Oil Injector
Use the diagnostics software to t est the oil injec-
tion p ump circuit. Refer
TESTS on p. 173.
Fuel Pump
Use the diagnostics software to test the fuel pump
circuit. Refer to Fuel Pump Static Test on p. 85.
Overheat
This test is used to check the "ENG TEMP" or
"HOT" circuit of the Engine Monitoring system.
Oil Fault
This test is used to check the "NO OIL" circuit of
the Engine Monitoring system.
Check Engine
This test is used to check the "CHECK ENGINE"
circuit of the Engine Monitoring system.
Tachometer
This test is used to check operation of the tachom-
eter circuit.
66
to OILING SYSTEM

Dynamic Tests

Dynamic test s are pe rformed with the outboa rd
running.
Dynamic Tests Screen
Ignition Test
This test mo mentarily disables the ign ition and
fuel injection circuits to o ne cylinder. By d ropping
one cylinder, RPM and run ning q uality ch anges
can be observed . Refer to DYNAMIC TESTS on
p. 77.
Fuel Test
This test mo mentarily d isables one fu el in jector
circuit. By dropping on e cylinder , RPM and ru n-
ning qu ality change s can be observe d. Refer to
DYNAMIC TESTS on p. 77.
Prime Oil
This test is used to cycle the oil injection pump for
priming the o iling syst em. Per form th is test with
outboard running to activate oil injection pump.
008570