Using The Analyze Module - Actel Silicon Explorer II User Manual

Using the Analyze Module

"Show Nets" or "Show Pins". See Figure 2-4 for examples of the two
types of displays.
"Show Nets" Display
Figure 2-4. Command Module Display Styles
If you cannot find a net, it is possible that the net was optimized by
Designer. Refer to "Troubleshooting" on page 27 for more information
about the limitations in probing Actel devices using Silicon Explorer.
Note: This section does not apply to Silicon Explorer II Lite, since it
does not contain the Analyze module.
Open Silicon Explorer II and check the status in the lower right corner
of the display. If you have properly selected the COM port and
powered up Silicon Explorer II, then the status is IDLE. The Analyze
Using the Analyze Module
"Show Pins" Display
13