Advertisement
FIG 10.
FOR THAW MODELS
Using the screws provided, fit the air duct in the pre
punched holes to the centre of the back wall and
roof. See figure 11.
FIG 11.
FITTING RAMPS
Fit the ramp to the front of the room with the screws
provided. See figure 12. Insert the screws into the
front face of the floor through the pre-punched
holes, do not screw in all completely, i.e. leave
them protruding by approximately 3mm. Hook the
ramp over the screws. The ramp is intended to be
removable for ease of cleaning.
FIG 12.
INSTALLATION - RMR2T - ROLL IN MODULAR RUBY
FITTING FINISHING ANGLE (15MM FLOOR)
Fit finishing angle with screws provided. See figure
13.
FIG 13.
FITTING THE AIR BAFFLE
Fit the air baffle to the two fan pods. See figure 14
& 15.
FIG 14.
Fan Guard
Fold tabs in by hand and
fix to pod liner with 8 x
1/2" S/Steel screws
Finishing angle
Screw
Fix flange to
Screw
fan guard with
8 x 1/2" S/Steel
screws
Baffle
Screw
9
Advertisement
