Advertisement
INSTALLATION - RMR1T - ROLL IN MODULAR RUBY
Ensure all the walls and jambs have been located
and camlocked together before lowering the roof
section onto them.
Please note that the roof is very heavy.
See figure 5.
FIG 5.
Fit the floor angle if supplied and then fit the door
onto the door jamb by lowering vertically onto the
hinges. See figure 6.
FIG 6.
Connect the door heater if provided.
IMPORTANT: electrical connection of the
heater must only be carried out by a qualified,
skilled and competent electrician. For further
information, refer to the equipment wiring
diagram.
6
FOR THAW MODELS
Fit the duct to the rear wall, right hand side wall and
roof inner with the screws provided in the pre-
punched holes. See figure 7.
FIG 7.
Advertisement
