Advertisement
FIG 10.
Connect the door heaters if provided.
IMPORTANT: electrical connection of the
heater must be carried out by a qualified,
skilled and competent electrician. For further
information, refer to the equipment wiring
diagram.
FITTING ROOF ANGLE AND FLOOR TIE
PLATE
Screw the roof angle to the roof and jambs as
indicated using the M5 screws supplied. See figure
11 (rooms with floors) or figure 12 (floorless rooms).
Screw the floor tie plate to the floor and jambs as
indicated using the 8 x 1/2 screws supplied. See
figure 11.
Please note that the floor tie plate is only
supplied with rooms with floors. Floorless
have either floor angle or floor tray.
FIG 11.
INSTALLATION - RMR3T - ROLL IN MODULAR RUBY
FIG 12.
FITTING RAMPS
Fit the ramp to the front of the room with the screws
provided. See figure 13. Insert the screws into the
front face of the floor through the pre-punched
holes, do not screw in all the way, leave them
protruding by approximately 3mm. Hook the ramp
over the screws. The ramp is intended to be
removable for ease of cleaning.
FIG 13.
FITTING FINISHING ANGLE (15MM FLOOR)
Fit finishing angle with screws provided. See figure
14.
1397mm
60mm
865mm
60mm
60mm
462mm
462mm
60mm
1397mm
160mm
160mm
160mm
160mm
160mm
160mm
60mm
865mm
60mm
60mm
462mm
462mm
60mm
13
Advertisement
