Advertisement
INSTALLATION - RMR2T - ROLL IN MODULAR RUBY
FIG 5.
FIG 6.
Ensure all the walls and jambs have been located
and camlocked together before lowering the roof
section onto them.
Please note that the roof is very heavy.
See figure 7.
FIG 7.
8
Fit the roof angle to the jambs and roof using the
screws provided. See 'Fitting Roof Angle and Floor
Plate'.
Fit the floor angle if supplied and then fit the doors
onto the door jamb by lowering vertically onto the
hinges. See figure 8.
FIG 8.
Connect the door heaters if provided.
IMPORTANT: electrical connection of the
heater must only be carried out by a qualified,
skilled and competent electrician. For further
information, refer to the equipment wiring
diagram.
FITTING ROOF ANGLE AND FLOOR TIE
PLATE
Screw the roof angle to the roof and jambs as
indicated using the M5 screws supplied. See figure
9 (rooms with floors) or figure 10 (floorless rooms).
Screw the floor tie plate to the floor and jambs as
indicated using the 8 x 1/2 screws supplied. See
figure 9.
Please note that the floor tie plate is only
supplied with rooms with floors. Floorless
have either floor angle or floor tray.
FIG 9.
Advertisement
