Advertisement
Quick Links
Advertisement
Related Manuals for Trotec BD8M
Summary of Contents for Trotec BD8M
- Page 1 BD8M OPERATING MANUAL LASER DISTANCE MEASURING DEVICE...
-
Page 2: Table Of Contents
Information marked with this symbol indicates that the Otherwise do not use the device. operating manual must be observed. • Observe the storage and operating conditions (see Technical data). laser distance measuring device BD8M... -
Page 3: Information About The Device
Do not use the device in potentially explosive atmospheres, or for measurements in liquids. Never point it at people or animals. Device description Trotec accepts no liability for damages resulting from improper The laser distance measuring device BD8M is used to determine use. - Page 4 C/Off button Press briefly: deleting last value Press for a long time: switching the device Designation Display Wrist strap Belt clip Operating elements Battery compartment with cover Tape measure Cross line laser Laser Return button laser distance measuring device BD8M...
- Page 5 BD8M Measurement value display bottom section: • 2 x 1.5 V battery AAA last measured value/result of a calculation • 1 x Quick guide +/- indication: Addition/subtraction of measured values Front reference point Rear reference point Laser active laser distance measuring device BD8M...
-
Page 6: Transport And Storage
4. You can return to the measuring menu by briefly pressing the C/Off button (13). 3. Put the cover of the battery compartment back onto the device and tighten it with the screws. laser distance measuring device BD8M... - Page 7 You can use the non-stop measurement • Twofold indirect height measurement function with MAX/MIN/current value display for performing the following measurements, for example: • measuring a diagonal (MAX value) • determining the perpendicular length to a wall/floor area (MIN value) laser distance measuring device BD8M...
- Page 8 ð The area value is indicated as an intermediate result in ð The second measured value is displayed in the the lower measured value display (20). "Indication of measured value 2" (19). ð The overall result will be indicated in the lower measurement value display (20). laser distance measuring device BD8M...
- Page 9 ON/MEAS button (10) once to perform a measurement. ð The third measured value is displayed in the "Indication of measured value 2" (19). ð The line segment to be determined is displayed as result in the lower measurement value display (20). laser distance measuring device BD8M...
- Page 10 ð The tape measure is blocked once the length is pulled out. 2. Read the measured distance from the scale on the tape measure. ð The tape measure indicates the distance in 0.000 m (lower scale) and in 0.0 ft (upper scale). laser distance measuring device BD8M...
-
Page 11: Maintenance And Repair
Fault Cause Remedy The device can no The batteries are Insert new longer be switched on. empty. batteries (see chapter Display segments are The battery voltage Maintenance). only faintly visible or is too low. flicker. laser distance measuring device BD8M... - Page 12 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...