Notes regarding the operating manual......... 2 Safety .................. 2 Information about the device.......... 4 BD7A Transport and storage............ 5 Operation ................ 6 https://hub.trotec.com/?id=42892 Maintenance and repair ............ 9 Safety Errors and faults.............. 9 Read this manual carefully before starting or using the Disposal ................. 9 device. Always store the manual in the immediate vicinity...
Page 3
Never point it at people or animals. carried out by an authorised specialist company! Trotec accepts no liability for damages resulting from improper Warning of explosive substances use. In such a case, any warranty claims will be voided.
Operating elements Information about the device Device description The cross line laser BD7A projects laser lines on surfaces, e.g. to drill holes in a straight line – similar to using a spirit level. The device comes with the following features: • Projects light-intense laser lines up to a distance of 10 m •...
Technical data Transport and storage Parameter Value Note Model BD7A If you store or transport the device improperly, the device may be damaged. Device dimensions 60 x 60 x 115 mm Note the information regarding transport and storage of (length x width x height) the device.
3. Connect the charging cable to the device's micro USB port. Operation Charging the battery The battery is partially charged upon delivery to avoid damage to the battery caused by a deep discharge. Info Upon delivery, the battery is only slightly charged. Therefore, please charge the battery for at least 5 hours before using the device for the first time.
Page 7
Info Using the multifunctional mount When exceeding the permissible inclination range of Proceed as follows to use the multifunctional mount with the 3°, the lasers begin to flash and the levelling indicator device: "NO Level" (9) will be illuminated in red. If so, self- 1.
Page 8
Application example for the universal clamp Application example for the suction cup 1. Loosen the locking screw (12) and push the clamping 1. Make sure that the surface is smooth and clean. jaws (15) apart until they fit onto the carrier (here: shelf). 2.
Maintenance and repair Disposal Charging the battery The icon with the crossed-out waste bin on waste The battery should be charged prior to initial start-up and when electrical or electronic equipment stipulates that this equipment the battery is low. To do so, please follow the instructions in the must not be disposed of with the household waste at the end of chapter Operation.
Page 10
Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...