Enable Safety Cameras; Audible Warning; Route Recalculation; Automatic - Clarion N.I.C.E. 430 Owner's Manual

Speed limit
25 mph
40 mph
50 mph
60 mph
72 mph
80 mph

5.1.6 Enable Safety Cameras

N.I.C.E 430 can warn you when you approach known speed and red light cameras
previously uploaded or copied into the device, or saved manually in the software.
You can save cameras using the POI button in the Cursor menu (Page 35), and then
the Add Cam button. The types and parameters of speed cameras are explained
here: Page 57.
In this section you can enable or disable the warning for known cameras, and you
can also fine-tune the way N.I.C.E 430 warns you when you approach one of these
cameras.
Note: Detecting the location of speed cameras may be prohibited by law in certain
countries or regions. Be sure to check if it is legal to turn on this warning or not
before doing so.

5.1.6.1 Audible Warning

You can disable the audible warning; have a simple warning (when you are warned
only if you exceed the speed limit when approaching a camera); or a complex sound
with repeated beeps as you approach the camera. In case of section control
cameras, you will also hear these beeps while you are between the two cameras
(these cameras work in pairs).
You are warned well in advance. The distance N.I.C.E 430 starts warning you before
reaching the camera depends on your speed. The higher the speed, the earlier the
warning starts.

5.1.7 Route Recalculation

Once a route is planned, this setting will tell N.I.C.E 430 what to do when you deviate
from that route.

5.1.7.1 Automatic

The route will be recalculated automatically a few seconds after you go astray.
64
Warning at
35 mph (=25 mph + 10 mph)
50 mph (=40 mph + 10 mph)
60 mph (=50 mph + 10 mph)
63 mph (=60 mph + 5%)
76 mph (=72 mph + 5%)
84 mph (=80 mph + 5%)