Step 12 Lighting The Fireplace; After The Installation - Heat-N-Glo Grand-50-D Manual

Step 12. Lighting the Fireplace
After reviewing all safety warnings, checking the fireplace
for gas leaks, checking that the vent system is unobstructed,
and checking for faulty components, be sure power is on
and proceed with lighting fireplace.
WARNING: PLEASE REFER TO THE USER'S
!
MANUAL FOR ALL CAUTIONS, SAFETY, AND
WARNING INFORMATION PERTAINING TO THE
LIGHTING AND OPERATION OF THE FIREPLACE.
FIREPLACE OPERATION
This fireplace is designed to be operated with the remote
control found in the manual bag. To start main burner fire,
push the on-off button on the left while pointing remote in
direction of fireplace.
If the remote control does not start the fire, check that the
antenna wire is installed on the two clips located below the
lower louver and on top of the lower flange (see Figure 31).
BATTERY BOX
ANTENNA WIRE
TWO CLIPS
FIGURE 31
In certain situations the remote control will be more effective
if pointed slightly away from remote receiver within the fire-
place.
When flames appear from main burner, the rear log may be
lit if desired by pushing center button (marked with flames).
It is recommended that the rear log always be turned off
before turning off main burner.
The third button is used to control the optional fan. If a fan is
installed it can be turned to high, medium, low, or off with
this button.
To avoid accidental lighting or if fireplace is not going to be
used for an extended period the remote receiver should be
unplugged from the electrical box (inside the lower louver on
the far right side).
In the event of a power failure the fireplace main burner can
be operated by inserting two D-cell batteries into the battery
box located left of center behind the lower louver, and turn-
ing on the rocker switch to the right of it. Batteries should be
removed when power is restored, as normal operation will
drain them. Switch must also be returned to off position to
allow operation by the remote control.
IMPORTANT SAFETY FEATURE
A private code can be set to prevent operation by other
transmitters near by.
1. Unplug remote from electric box at lower right side of
fireplace.
2. Remove back cover of transmitter (see figure 32).
TRANSMITTER
SWITCH
SWITCH
DETAIL
FIGURE 32
3. Slide the code switches to your choice of UP and DOWN
positions.
4. Remove valve cover from valve plate by removing two
screws at bottom of cover.
5. Remove receiver from valve plate behind cover by remov-
ing two screws (¼" hex head). Receiver can then be slid
out and turned over without disconnecting wiring.
6. Remove cover from receiver by removing 4 Phillips head
screws.
7. Locate code switches in receiver. Slide the numbered
switches to exactly match settings on transmitter.
8. Replace cover and check operation by plugging remote in
and turning fireplace on and off before reinstalling receiver.
9. Unplug remote again and reinstall remote and valve cover.
10. Plug remote into electric box.

After the Installation

LEAVE THIS INSTALLATION MANUAL WITH
!
THE APPLIANCE FOR FUTURE REFERENCE.
26
RECEIVER
SWITCHES
SWITCH DETAIL