Lamp Replacement - Christie 38-RS1002-01 User Manual

APPENDIX
CAUTION
For continued safety, replace with a lamp
assembly of same type.
Allow a projector to cool for at least 45
minutes before you open Lamp Cover. Inside
of a projector can become very hot.
Follow these steps to replace lamp assembly.
1
Check number of lamp to be replaced on Lamp Status Display.
Turn off a projector and disconnect AC Power Cord. Allow a
2
projector to cool down for at least 45 minutes.
3
Remove two screws on Lamp Cover and press button to open
Lamp Cover. (See right figure.)
4 Loosen two screws and pull out Lamp Assembly to be replaced
by grasping handle.
5
Replace Lamp Assembly with a new one and tighten two screws.
Make sure Lamp is set properly
6
Replace Lamp Cover and tighten two screws.
Connect AC Power Cord to a projector and turn a projector on.
7
8
Reset Lamp Replacement Counter. (Refer to section "Lamp
Counter Reset" on page 42.)
NOTE : Do not reset LAMP REPLACEMENT COUNTER when
lamp is not replaced.
46

LAMP REPLACEMENT

CAUTION
Do not drop a lamp assembly or touch a glass
bulb! Glass can shatter and may cause injury.