Lamp Replacement; Lamp Replace Counter - Christie VIVID 38-VIV205-01 User Manual

Christie digital systems projector user's manual 38-viv205-01

Hide thumbs Also See for VIVID 38-VIV205-01:

User manual (46 pages)

Table Of Contents

Table of Contents

When the life of the Projection Lamp of this projector draws to an end, LAMP REPLACEMENT indicator lights yellow. When

a projected image becomes dark or the color of an image becomes unnatural, replacement of Projection Lamp is required.

CAUTION

For continued safety, replace with a lamp

assembly of same type.

Allow the projector to cool for at least 45

minutes before you open Lamp Cover. The

inside of the projector can become very hot.

Follow these steps to replace lamp assembly.

Turn off a projector and disconnect AC plug. Allow a projector to

cool for at least 45 minutes.

Loosen 2 screws with a screwdriver and open Lamp Cover.

Loosen 2 screws with a screwdriver and pull out Lamp Assembly

by grasping Handle.

Replace Lamp Assembly with a new one and tighten 2 screws

back. Make sure that Lamp Assembly is set properly. Replace

Lamp Cover and tighten 2 screws.

Connect AC Power Cord to a projector and turn it on.

Reset Lamp Replace Counter (refer to section "Lamp Replace

Counter" below).

NOTE : Do not reset Lamp Replace Counter when Projection

Lamp is not replaced.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give the following

information to the dealer.

Model No. of your projector

Replacement Lamp Type No. : 03-000667-01P

Be sure to reset Lamp Replace Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP

REPLACE Indicator stops lighting.

Turn projector on, press MENU button and ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT button(s)

to move the red frame pointer to SETTING Menu icon (refer to page 37).

Press the POINT DOWN button to move the red frame pointer to "Lamp counter reset" and then press SELECT button.

The message "Lamp replace counter reset?" will display. Move pointer to [Yes] and then press SELECT button.

Another confirmation dialog box will appear and select [Yes] to reset Lamp Replace Counter.

Do not reset Lamp Replace Counter unless Projection Lamp is replaced.