Table of Contents
Advertisement
Troubleshooting
Phenomenon
Spin time is extended/
Spin speed is low.
There are excessive foams.
Foam is left in gasket after
a program is finished.
Button does not respond.
There is smell of rubber
comes from the washing
machine.
Drying performance is
poor.
It takes too much time to
dry.
• Because there is Fuzzy control in your machine, it can
inspect the balance when spinning. In order to protect the
machine, when the clothes is unbalance, it will expend the
spinning time or reduce speed to keep the clothes balance,
or spin in a lower speed.
• When there are excessive foams, the time on the display
will cease for a spell, meanwhile the machine is eliminating
the foams rather than fault, and the machine will
automatically return to normal program if finished.
• Make sure you use the recommended types of detergent as
appropriate.
• Use"low foam" detergent to prevent oversudsing.
• Reduce the detergent amount for soft water, small loads, or
lightly soiled loads.
• Check if control panel is clean. Wipe off water or dirt with soft
cloth. Remove stickers or tapes.
• Touch the panel directly with finger. Operating with gloves,
bandages, nails, or other sharp objects does not respond.
• Press the center of the button.
• Do not take your finger off the button immediately.
• Check if multiple buttons are not pressed.
• Rubber smell may come from the washing machine when
using drying function in the beginning.
• The smell will be reduced with the use of drying function.
・ Select the highest spin speed available.
• Do not overload.
• Sort heavy items from lightweight items.
• Check the water inlet and outlet is in normal situation.
• Make sure the drain pump filter is not clogged.
• Ensure the program is set correctly.
• Decrease the amount of clothes.
• Clothes must be fully dehydrated before put into drum.
• Please confirm whether the ambient temperature is within
the allowable range.
36
Solution
Advertisement
Table of Contents
